Set Stollen und Applikator für Floating Boots Winter Stud Pack (16 UNITS) and 1 application tool

Materiel needed for installation :

Installation :

Mark the points where you want to place the studs. You can follow the pattern shown on the photos below, Fig1. for "Sport" and Fig2. for "Endurance"
Pre-drill 3 mm holes on the marked points with a 4 or 4.5 mm drill bit.
Lock the stud applicator into position on the drilling machine. Position the end of the stud tread over the drilled hole and slowly drill the stud into the hole.

IMPORTANT :

Before installing the studs, make sure that the boots are the approriate size and that the horse is used to wear them.
Install the studs always symmetrically for a correct balance.
While drilling, make sure that the stud does not perforate the sole completely and passes to the inside of the sole. This can happen on older boots with worn soles.
Always use your best judgement when going to ride in slippery conditions. The studs provide extra grip, but they have their limits !
Remove the studs when they are not neccessairy. You can keep and reinstall them when you need them.